Gigaset AS300A Duo handleiding

Gigaset AS300A Duo

Bekijk hier de Gigaset AS300A Duo handleiding. Het bekijken en downloaden van deze Dect/voip-telefoon handleiding is geheel gratis.

Merk
Gigaset
Model
AS300A Duo
Product
Dect/voip-telefoon
EAN
4250366820033
Taal
Engels
Bestandstype
PDF
Gigaset AS200-AS200A-AS300_AS300A_UK _ A31008-M2208-L101-2-7619
Quick start guide
AS200 - AS200 A
AS300 - AS300 A
GIGASET. INSPIRING CONVERSATION.
GIGASET HELPLINE: 0845 3670812
Pack contents
If you have purchased a model
with multiple handsets the
package should contain two
batteries, a battery cover, a
charging cradle
8 with mains
adapter
9 for each additional
handset.
1
1
one Gigaset AS200/AS200A/AS300/AS300A Base station
2 one mains adapter
3 one Gigaset AS200H/AS300H handset
4 one phone cord
5 two batteries
AS185
GIGASET. INSPIRING CONVERSATION.
2
3
4
5
7
6
6 one battery cover
7 this Quick start guide
or
89
Connecting the base station
¤ Connect power adapter 1 and
Phone jack
2 to the base and
place the cable recesses.
Please ensure the power lead is
fully inserted.
Please note:
u The mains adapter must always be connected, as the Phone will not operate
without a mains connection.
u Always use the power adapter and Phone cord supplied. Pin connections on
Telephone cables can vary.
Connecting the charging cradle (if included)
1
1
1
2
¤ Plug the mains adapter into the
plug socket
2.
¤ Connect the flat plug from the
mains adapter
1.
If you need to disconnect the plug from the
charging cradle, press the release button
3 and
disconnect the plug
4.
1
2
4
3
Preparing the handset
Initial charging and discharging of the batteries
¤
Insert the batteries the right way
round. The polarity is indicated
in/on the battery compartment.
¤ Then slide the battery cover back
into the main casing until it clicks
into place.
If you need to open the battery cover, for
instance to replace the batteries, place
your fingertip in the grooved area on the
top of the cover and slide down.
The correct charge status can only be displayed if
the batteries are first fully charged and discharged.
¤ Place the handset in the charger
for 7 hours.
7h
Then remove the handset from the charger, make and receive Phone calls, setup the
Phone etc. and do not put it on the charger until the batteries are fully discharged.
Setting the date and time
Set the date and time so that the correct date and time can be assigned to incoming
calls, and so that the alarm can be used.
Date: DD: MM: YY
“TOK
INT MENU
¤ Press the key below MENU on the
display screen to open the main
menu.
Date/Time
OK
¤ Press the bottom of the control
key ...
... until the
Settings menu item
appears.
¤ Press the key below OK on the
display screen to confirm your
selection.
The
Date/Time menu item appears on
the display.
¤ Press the key below OK on the
display screen to open the input
field.
Settings
OK
¤ The active cursor position is flashing.
Enter day, month and year as an
6-digit number via the handset,
e.g.
Q11Q1Q for 01/10/10.
Message indication
Message Indication Key on handset will flash to indicate one or all of the
following events:
u missed calls (if caller ID is enabled for your line numbers will be shown)
u new messages on the answer machine (AS200A/AS300A only)
Activating/deactivating the answer machine (AS200A/AS300A only)
MENU ¢ Voice Mail ¢ OK ¢ Answer Mach. ¢ OK (
= on)
If the answer machine is activated, the answer machine icon ± will be displayed in
the header.
To retrieve your messages, just press the flashing
key on your handset.
Dial tone
The dial tone will only be heard when pressing the c call button for 2 seconds.
A short press will open the redial list.
You can also use the
d
speaker button (AS300/AS300A only).
Display in idle status
u 2: internal number, if more then one handset is registered
u ±: answer machine is activated (AS200A/AS300A only)
u Battery charge status:
= e V U (empty to full)
= flashes: batteries almost empty
e V U flashes: charging procedure
Registration handset
Your handsets should already be registered by default, if your handset is flashing the
text "No Base" then it can be that:
u Your base station is not switched on, please check if the power supply is connected
properly.
u There is too much distance between the handset and base.
u Your handset has not been pre-registered in the factory.
In the case that the handset has not been pre-registered, or you want to register an
additional handset to your base station, use the manual registration procedure
below.
Automatic registering procedure
Manual registration procedure
1. On the handset:
MENU ¢ Settings ¢ OK ¢ Handset ¢ OK ¢ Register HS ¢ OK ¢ enter the
system PIN for the base and press
OK. Default PIN = 0000
2. On the base station:
Within 60 seconds of entering the system PIN, press and hold the registration/paging
key (min. 3 seconds). Registration takes approx. 1 minute.
You can register up to four handsets to your base. You can also register other Gigaset
handsets and handsets from other devices with GAP functionality.
V
Put into base
MENU
V
Put into base
MENU
Place the handset with the
display facing up in the base
station.
The handset registers
automatically. Registration
can take up to 5 minutes.
Do not remove the handset
from the base station during
this time.
V
Put into base
MENU
V
Registering
Frequently asked questions
Q: There is no dial tone.
A: Press call button for 2 seconds (long press) to obtain dial tone.
A short press opens the redial list.
Q: The line is crackling / not clear.
A: Have you used the new line cable provided? Please do not use an old cable.
Q: The display is not clear / seems to be broken.
A: The display is protected by a plastic film, please make sure you have removed
the protective film.
Q: The handset is not registered.
A: If your handset is not registered, please follow the Registration handset procedure.
(Described on this page)
Q: The caller ID is not working.
A: Have you subscribed to this service (CLIP) from your provider?
Q: Message indicator flashing and I cannot retrieve my message.
A: Message indicator will flash to indicate missed calls. (Described on this page)
Please check:
Have you used the phone cord supplied
Have you fully inserted the power cable into the base station
Have you inserted the batteries correctly
Have you charged the batteries for 7 hours
Have you set up the Date/Time
To download the latest manuals, visit our web-site: http://www.gigaset.com
You have questions? As a Gigaset customer, you can take advantage of our comprehensive
service offerings. You can find help quickly in this User Manual and in the service pages of
our Gigaset online portal: http://www.gigaset.com
Product may not be fully compatible with the national telephone network. It is clearly
specified on the box near the CE mark for which country/countries the equipment has been
developed. If the equipment is used in a manner inconsistent with this advice or with the
instructions of the manual and on the product itself, this may have implications on the
conditions for warranty or guarantee claims (repair or exchange of product).
In order to make use of the warranty, the product purchaser is asked to submit a receipt
which proves the date of purchase (date from which the warranty period starts) and the
type of goods that have been purchased.
If you have problems setting up or operation this product please call
GIGASET UK HELPLINE 0845 3670812
GIGASET IRL HELPLINE 1850 777277

Vraag over de Gigaset AS300A Duo?

Wanneer u een vraag heeft over de "Gigaset AS300A Duo" kunt u die hier stellen. Zorg voor een duidelijke omschrijving van uw probleem zodat andere gebruikers en/of de redactie u van een passend antwoord kunnen voorzien.

Hoe zet ik de rood knipperende berichtenmelding uit ?

, 2 jaar geleden
0

Onlangs de gigaset as 300aduo gekocht. Nu gaat de telefoon 3 keer over en gaat over naar het antwoordapparaat. Hoe moet ik dit wijzigen zodat de telefoon 6 keer overgaat alvorens de boodschap op het antwoordapparaat komt. Graag zsm antwoord

, 4 jaar geleden
0

Goedemorgen, Wij hebben zaterdag de gigaset as300aduo gekocht maar ik krijg de handset niet aangemeld. Hoe kan ik dit oplossen. Met vriendelijke groet, Ingrid de Groot

, 4 jaar geleden
0

Ilk heb de alarm aan gezet en krijg het er niet meer uit

, 1 jaar geleden
-2

Koop gerelateerde producten:

Product specificaties

Prestatie
Soort DECT-telefoon
Maximum indoorbereik 50 m
Maximum outdoorbereik 300 m
Aantal melodieën 10
Antwoordapparaat yes
Opnametijd 12 min
Inhoud van de verpakking
Inclusief headset yes
Aantal handsets inclusief 2
Beheerfuncties
Klok met kalender yes
Personalisatie Menu
Navigatietoets yes
Telefoonfuncties
Luidspreker   -
Aantal handsets mogelijk 4
Polyfone beltonen   yes
Capaciteit telefoonboek 60 entries
Oproep-management
Nummerherkenning yes
Bel-lijn identificatie presentatie (CLIP) yes
Gesprekstijd timer yes
Capaciteit nummerlijst 10
Design
Backlight toetsen yes
Geïntegreerde antenne yes
Montagewijze Bureau/muur
Kleur van het product Zwart
Ouderentelefoon -
Beeldscherm
Ingebouwd display yes
Beeldscherm, aantal kleuren Monochroom
Tekstregels 3
Backlight-kleur Amber
Beeldschermdiagonaal   1.5
Poorten & interfaces
Plug and play   yes
Draadloze verbindingen yes
Aansluiting voor netstroomadapter yes
Overige specificaties
Ingebouwde camera no
Mac-compatibiliteit   no
Ophangsysteem voor aan de muur yes
Gewicht en omvang
Afmetingen basisstation 126 x 55 x 126 mm
Afmetingen handset (BxDxH) 49 x 31 x 147 mm
Energie
Type accu/batterij   AAA
Gesprekstijd 20
Standby tijd 220
Ondersteund aantal accu's/batterijen 2
Indicatie
Accucapaciteit yes
Batterij-oplaadindicatie yes
Certificaten
Energy Star-certificaat -

Gerelateerde producten: